Remote Support

• Related Articles

• Table cutout scheme - Pro-E and Mr. Series

  Cutout scheme to prepare the workbench for the Edgers M40 (Pro Series), M24 and M22 (Mr. Series)

• E-Tess TOUCH SCREEN CALIBRATION

  In case of unresponsiveness or unprecise touch commands, is recommended to calibrate the touch screen following the steps below: 1. At the upper bar, press the setup button to access the configuration/maintenance menu. 2. Select the "Touch screen ...

• Problems with bevel position

  1 - Verify the transfer movement of the wheels Verify if there is no lens residues inside the cutting area blocking the transfer movement (right-left) of all wheels. Presence of burrs, parts of lenses, or falling chuck can affect the right movement. ...

• Spindles Replacement Tutorial

  Introduction: This article provides information on how to change the spindles of the Mr. Blue, Mr. Orange and Pro-E lens finishing systems. The need of replacement is indicated automatically by the machine when replacement is necessary. The indicator ...

• Grooving position adjustment

  This article is applicable for Delta, Jess D, Jess and Jessie Checking the grooving position - Place a lens on the machine. - Cut a grooved square K39 barcode in manual mode at 50% - Do not perform the test on glass (mineral). - It should be in the ...

• Recent Articles

• How to remove the IPL cartridges?

  To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.

• How to remove the IPL cartridges?

  To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.

• How to remove the IPL cartridges?

  To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.

• How to remove the IPL cartridges?

  To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.

• What are the benefits of LM LLT?

  It is fast—a treatment lasts 15 minutes. It is painless. It grants immediate relief to the patient. It is easy and safe for the operator. It is plug-and-play and does not require the operator to be constantly present during the treatment.