Spindles Replacement Tutorial
Introduction:
This article provides information on how to change the spindles of the Mr. Blue, Mr. Orange and Pro-E lens finishing systems. The need of replacement is indicated automatically by the machine when replacement is necessary.
The indicator of the third wear-out threshold is displayed beside the maintenance menu in the top of the screen.
The wrench icon flickers.
On the spindle maintenance screen a warning icon appears next to the spindle concerned.
The bar graph flickers.
The bar graph flickers.
IMPORTANT
- Spindle maintenance is used to preserve the GMD module seals
- Always follow the maintenance as indicated by the machine automatically
- The non compliance of the GMD maintenance may cause serious damage to the entire GMD module
Tutorial:
Before you start:
Check if you have the tools and materials listed below:
CX 4230 - Grease
CX1243 - Torx T10 Key
M24A76 - GMD locking tool
M24A78 - GMD Spindle socket
GMD module spindles changing procedure Step by step pricture
2 - Step by step video
Submit a ticket
Remote Support
Related Articles
Error Codes_B21-B41_L11-L12-L13-L14-L20_M22-M24-M25
Opt 1 Please contact your technician with the product data. Opt 1000 Opt 1001 Internal error. Please contact your support technician.+48 Opt 1002 Unforeseen error. Please contact your support technician. Opt 1003 No internal memory. Please contact ...How to carry out the autotests on Essilor edgers
To test the proper performance of the edger, select from your work screen. 1. Edger autotests 2. Initialisation and rotation of lens shafts 3. Reproducer: lens shaft raising and lowering 4. Right feeler movement 5. Left feeler movement 6. Closing of ...E-Tess TOUCH SCREEN CALIBRATION
In case of unresponsiveness or unprecise touch commands, is recommended to calibrate the touch screen following the steps below: 1. At the upper bar, press the setup button to access the configuration/maintenance menu. 2. Select the "Touch screen ...Adjust the position of the bevel and groove
After beveling a lens, if the position of the bevel or groove appears to be systematically too forward or backwards, you can adjust it. To access this menu on the beveling machine's work screen, select: The following screen is displayed: 1 - Bevel ...Grooving position adjustment
This article is applicable for Delta, Jess D, Jess and Jessie Checking the grooving position - Place a lens on the machine. - Cut a grooved square K39 barcode in manual mode at 50% - Do not perform the test on glass (mineral). - It should be in the ...
Recent Articles
How to remove the IPL cartridges?
To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.How to remove the IPL cartridges?
To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.How to remove the IPL cartridges?
To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.How to remove the IPL cartridges?
To remove any of the terminals, hold the hand piece with both hands. Place the thumb under the terminal and push up to disengage. Use your other hand to slide the terminal out.What are the benefits of LM LLT?
It is fast—a treatment lasts 15 minutes. It is painless. It grants immediate relief to the patient. It is easy and safe for the operator. It is plug-and-play and does not require the operator to be constantly present during the treatment.